Specifications - Sony LT 100 Gebrauchsanweisung

10. Specifications

Product configuration
[Main unit]
[Optional boards] Counter board
Functions and performance
Item
• 6-digit LCD with backlight
Displays
For displaying the measurements, modes, etc. of the counter board(s) selected using a key from
the maximum of 5 boards
• Go/No Go judgement LED: Green (go), red (high, low) For displaying the Go/No Go judgement
results for up to 10 channels.
• Board selection LED: Yellow
For displaying the board which has been selected
• Valid for the counter board displayed Reset/recall, preset value setting, comparator value setting,
Key switches
mode setting
• Display board switching
• I/O (8-pin DIN connector)
Main unit
overall judgement output, overall reset/recall input, overall start/hold input, overall alarm output
• Measuring unit input (10-pin mini-DIN connector) 2 channels
Counter board
• I/O (28-pin half-pitch connector)
Go/No Go judgement output, reset/recall input, start/hold input, alarm output, comparator value
switching input, mode switching input
• I/O (36-pin micro-ribbon connector) BCD data output, data request input, ready output, set input,
BCD board
channel selection input, overall alarm output
• RS-232C (8-pin mini-DIN connector)
RS-232C board
• Link input, link output (8-pin mini-DIN connector)
• EXT.IN (8-pin mini-DIN connector, mini jack)
Reset function Resetting of position data using reset key and external input; preset values are recalled when position
data has been preset
Preset function Setting of preset values using preset key and RS-232C command; preset values are recalled using
reset key and external input
Comparator function 3-level comparator
Setting of comparator values using key switches and RS-232C command 3 sets of comparator
values can be set (and switched using external input) Go/No Go judgement: LED display (separate
display for all channels); external output of evaluation
Peak-hold function Maximum value, minimum value, peak-to-peak value measured
Measurement started using external input and RS-232C command
Link function Output of measuring unit data for 40 channels (equivalent to 4 LT100 units) from RS-232C interface
of one LT100 unit, mode setting, etc. enabled (only when the RS-232C board is installed)
Input resolution 0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm selectable
Display resolution 0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm (0.00002", 0.00005", 0.0002", 0.0005") selectable
Direction Can be switched
LT100
: LZ60-P1/P2
BCD board : LZ60-B1/B2
RS-232C board : LZ60-C
(Using the link function, up to four LT100 units can
be connected.)
Specification
Up to 5 boards (for a total of 10
channel inputs) can be installed.
Only 1 board can be installed.
Only 1 board can be installed.
57