Commands - Sony LT 100 Gebrauchsanweisung

8-8. Commands

1. Command table
Unit number
Channel name : A to J
Command
The command structure is as follows. These commands are converted to ASCII code
and output from the connected device (personal computer, etc.)
Unit number Channel name
: 1 to 4
This is used for identifying each units when linking multiple LT100 display
units. When not using link connections, set to "1".
However, when requesting output for all units with the R command during
link connection, do not attach the unit number.
The correspondence between the counter board slot number, the input
channel name and the command channel name is shown in the table
below. Note that the channel name is fixed even when the counter
boards are not inserted in order from slot number 1.
However, do not attach the channel name when using the R, KEYON or
KEYOFF commands.
Slot number
1
2
3
4
5
:
Command
P-P
MAX
MIN
REAL
RCL
RES
START
P= ¥ ¥ ¥ ¥ ¥ ¥ ¥
CH%= ¥ ¥ ¥ ¥ ¥ ¥ ¥ Set comparator upper limit
CL%= ¥ ¥ ¥ ¥ ¥ ¥ ¥ Set comparator lower limit
SCN=%
CPON
CPOFF
r
R
KEYON
KEYOFF
¥ : Value to be set (Example: 123.456)
%: Comparator set number (1 to 3)
Command C L
R F
Input channel name Channel name
A
B
A
B
A
B
A
B
A
B
Operation
Switch to peak-to-peak value mode
Switch to maximum value mode
Switch to minimum value mode
Switch to current value mode
Recall the preset value
Reset
Start
Set preset value
Comparator set number setting
Counter board comparator value selection input enable
Counter board comparator value selection input disable
Request for output for one channel
Request for output for all channels
Allow use of front panel keys
Prohibit use of front panel keys
A
B
C
D
E
F
G
H
I
J
53