Sony LT 100 Gebrauchsanweisung Seite 15

Connecting a BCD board (LZ60-B1/B2) or a RS-232C (LZ60-C) board
1. Remove the blank panel from one of the BCD or RS-232C board connection slot on the
2. Secure the BCD board or the RS-232C board using the screws that tightened the blank
• The BCD or RS-232C board connection slots (EXT. 1, EXT. 2) can be used for either the
• Be sure to turn off the power before connecting the BCD board or the RS-232C board.
• Only one BCD board and one RS-232C board can be connected. Connecting two BCD
LZ60-B1/B2
rear panel and insert the BCD board or the RS-232C board.
panel.
BCD board or the RS-232C board. These boards operate in either slot.
Notes
Inserting or removing the BCD board or the RS-232C board during the power on may
damage the LT100 and the BCD board or the RS-232C board.
boards or two RS-232C boards at the same time will cause malfunction.
LZ60-C
9