Preset Functions; Go/No Go Judgement; Peak-Hold Function - Sony LT 100 Gebrauchsanweisung

4-6-3. Preset functions

• It is possible to set preset values for each measuring mode of the current, maximum, and
• For instructions on setting the preset value, please refer to P24, "5-2-1. Setting the

4-6-4. Go/No Go judgement

• Go/No Go judgement is carried out by comparing data from the current measuring mode
• This result is displayed on the front panel and output from the I/O connector of the
• The Go/No Go judgement result indicators on the front panel display all of the channels

4-6-5. Peak-hold function

• Stores the maximum, minimum, and peak-to-peak (maximum–minimum) values of the
• The above measuring mode is set using the keys on the front panel.
• The LT100 starts storing values on receiving a start signal from the start/hold pins (A
minimum values.
preset value."
(current value, maximum value, minimum value, or peak-to-peak value) to the
comparator upper and lower limits.
counter board. (Refer to P28 "6. I/O (Go/No Go judgement)".)
connected measuring probes regardless of the main display.
Result Display
High > Data > upper limit
Go \
?
Low
measured values.
channel: pin 2, B channel: pin !§) of the counter board's I/O connector, or when the
reset key has been pressed.
Operation
Start on ON signal from pin
2 or !§ of the terminals
Reset key is pressed
Condition
> >
Upper limit data lower limit
= =
Lower limit > data
Result
Starts storing from the current value.
Starts storing from zero.
When a preset value is set the LT100
starts storing from the preset value.
17