Sony LT 100 Gebrauchsanweisung Seite 33

Note
1 Three different comparator value settings can be stored in the memory. The operations
are as follows.
A CH CPH1 CPH2
CPL1 CPL2
↓ ↓
B CH CPH1 CPH2
CPL1 CPL2
• When the 3 settings are not required, press
• Changing the 3 different setting values is carried out by inputs via the BCD connector.
• When the I/O connector of the counter board is not connected, the setting is CPH1 and
CPL1. However, when an optional LZ60-C RS-232C board is installed, three sets of
comparator values can be switched by the RS-232C commands.
2 When the
key is pressed to set the CPL the polarity ("+" or "–") of the CPH value
SET
may blink. This is because the CPH (upper limit) is less than the CPL (lower limit), and
the LT100 is in the CPH setting mode. In this case, return to and start from the CPH
setting.
3 If
key is not pressed, the previous setting is maintained.
SET
CPH3
CPL3
↓
CPH3
CPL3
key repeatedly.
COMP
27