Display Unit Pin Assignment - Sony LT 100 Gebrauchsanweisung

6-2. Display unit pin assignment

Connector being used
Pin description
The I/O logic in the pin status below differs for I/O 1 and I/O 2.
Overall Go/No Go output
This is set to ON when the Go/No Go judgement results of all connected measuring probes
are "Go". It is set to OFF in all other cases.
When connecting only one channel of the measuring probe to the counter board, set
"display setting" in the initial settings to "Only A". If "A and B" is set, the unconnected
channel will trigger an alarm and the overall Go/No Go judgement results will not be "Go"
even if the Go/No Go judgement results for all channels of the connected measuring probe
are "Go".
As viewed from the rear of the LT100.
Manufactured by Hoshiden Co., Ltd.
TCS2280-01-2011 (Display unit receptacle)
TCP1396-71-5011 (Plug and case: accessory)
I/O 1
Pin No. Signal
1 Overall reset/recall input
2 Overall start/hold input
3 Overall Go/No Go output
4 Alarm output
5 0 V
6 COM (+)
7 +5 V DC
8 COM (–)
Pin status I/O 1 I/O 2
ON L H
OFF H L
Note
3 7
5
6
8
2
1
4
Pin No.
1 Overall reset/recall input
2 Overall start/hold input
3 Overall Go/No Go output
4 Alarm output
5 0 V
6 COM (+)
7 N.C
8 COM (–)
I/O 2
Signal
31