Sony LT 100 Gebrauchsanweisung Seite 60

54
Note
• When there is a preset value the "RES" command will set the value to zero. To recall the
preset value input the "RCL" command.
• To set (switch) the comparator group number using the SCN command, be sure to first
use the CPOFF command to invalidate selection input from the counter board I/O
connector.
• The data set by the commands given in the table will not be stored by the LT100.
If the power is turned off the settings must be repeated.
• Provide intervals of at least 50 ms between command inputs.
However, provide intervals of at least 500 ms when outputting the data for all channels
during link connection.
• Even if you input the KEYOFF command, the counter board display data switching (
key) remains valid.
2. The output data format
Changing according to the initial settings (Refer to P20.).
1 Normal condition
Initial setting
1st byte
2nd byte
3rd byte
4th to 10th bytes : Numerical data (ex.123.456)
Initial setting
1st byte
2nd byte
3rd byte
4th byte
5th byte
6th to 12th bytes : Numerical data (ex.000.000)
Initial setting
Outputting according to the mode 1 format (statistical calculations) of the digital
printer P40 (sold separately).
2 When an alarm is triggered
Initial setting
For an overflow alarm
1st byte
2nd byte
3rd byte
4th byte
5th to 8th bytes
For a non-overflow alarm
1st byte
2nd byte
3rd byte
:
Normal output (set at time of shipping)
: Unit (1 to 4)
: Channel name (A to J)
: Sign ("+" or "–")
: (Outputting with measurement mode information)
: Unit (1 to 4)
: Channel name (A to J)
: Current mode
( N : Current value,
P : Peak-to-peak value,
I : Minimum value,
A : Maximum value)
: Unit (M: mm, I: inch)
: Sign ("+" or "–")
:
:
: Unit (1 to 4)
: Channel name (A to J)
: Sign ("+" or "–")
: F
: Numerical data
: Unit (1 to 4)
: Channel name (A to J)
: E