Sony LT 100 Gebrauchsanweisung Seite 25

2. Setting the input signal resolution (channel A)
One of 0.0005, 0.001, 0.005, or 0.01 mm can be chosen.
• Set the resolution to match that of the connected measuring
probe.
3. Setting the input signal resolution (channel B)
One of 0.0005, 0.001, 0.005, or 0.01 mm can be chosen.
• Set the resolution to match that of the connected measuring probe.
4. Setting the display resolution or direction (channel A)
One of 0.0005, 0.001, 0.005, 0.01, –0.0005, –0.001, –0.005, or
–0.01 mm can be chosen.
• With the measuring probe's spindle pushed in:
+: positive direction
–: negative direction
* When set to inches, values are chosen from 0.00002,
0.00005, 0.0002, 0.0005, –0.00002, –0.00005, –0.0002, and
–0.0005.
Note
The resolution cannot be set higher than the resolution set in step 2.
5. Setting the display resolution or direction (channel B)
One of 0.0005, 0.001, 0.005, 0.01, –0.0005, –0.001,–0.005, or –0.01 mm can be
chosen.
• With the measuring probe's spindle pushed in:
+: positive direction
–: negative direction
• When displaying A+B:
If you set the direction of A to "–" the data displayed is the calculation "–A+B".
The same can be done with B.
Note
• The resolution cannot be set higher than the resolution set in step 3.
• When the addition A+B is chosen the direction for B can be selected, but its
resolution will be the same as that of A.
6. Selecting the start input terminal function
(Refer to P28 "6. I/O (Go/No Go judgement)".)
: When the peak-hold function is chosen, setting this
terminal to ON sets the peak-hold value to the current
value and restarts the storing newly.
: With the current value measuring mode, setting this
terminal to ON stores the output and display of the
Go/No Go judgement at that point in time.
Note
With this selection, Go/No Go judgment output storage by the DRQ input for
the BCD board and the EXT.IN input for the RS-232C board is invalidated.
A
factory-set
A
factory-set
factory-set
19