Various Settings; Setting The Preset Value - Sony LT 100 Gebrauchsanweisung

5-2. Various settings

5-2-1. Setting the preset value

24
The following settings are performed for the counter board currently shown in the main
display. To set other counter boards, press
counter board. Note that in the setting modes there is always an indicator flashing.
1
Press key to select.
P
The A channel preset value setting mode.
2
Press key to select a polarity.
Press key to select a digit to be set.
The selected digit flashes.
Press key to select a numeral.
3
Press key to set.
SET
P for A channel flashes.
4
Press P key to select B channel preset value setting mode.
The polarity of the B channel flashes.
∗ When set to A channel display only (Only A) by the initial setting, the LT100 returns
to the measuring state.
5
Set the B channel in the same manner as 2.
6
Press key to set.
SET
Both A/B channel P flashes.
7
Press key to returns to the measuring state.
P
Both A/B channel P lights.
Note
• If
key is not pressed, the previous setting is kept.
SET
• In the P-P measuring mode, the preset value cannot be set.
key to switch the display to the desired
RESET
P
MODE COMP
A
RESET
SET
B
1, 4, 7 3, 6 2, 5
P
A