Interface Cable - Sony LT 100 Gebrauchsanweisung

7-3. Interface cable

• Use a shielded cable with diameter less than ø10 mm (ø0.39"), and length under 2 m
(78").
Also, leave the other side of the shielded cable open; do not connect it to earth (GND).
1 Fold back the braided wire of the portion to be held in the cable clamp.
2 Pass the cable through the back shell and solder it to the plug.
3 Insert the plug into the back shell, then fit the front and back shells together so that the
4 Tighten the cable clamping screw to secure the cable.
Assembling the supplied plug
2
hooks on the front shell are caught in the holes on the sides of the back shell.
Cable clamp
4
2
3
1 4
3
Cable
Fold back the braided wire and secure
with the metal clips.
Plug
Front shell
Back shell
41