Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. RS-232C Interface (only when the LZ60-C is installed)
8-1. Connector pin assignment
44
The RS-232C interface can be used to connect a personal computer to output measured
values or to control the display unit. It can also be used for connecting a P40 digital printer
(sold separately) to print measured values. (Refer to P20 "5-1-3. RS-232C settings".)
In addition, the measured data outputs and mode settings for up to 4 LT100 display units
can be performed from a single RS-232C connector using the link function.
Note
When not using the link function, leave the DIP switches on the RS-232C board at the
factory settings.
As viewed from the rear of the RS-232C board
Connector being used
RS-232C : TCS7587-01-401 (Hoshiden Co. Ltd.)
EXT. IN
: TCS6180-01-1010 (Hoshiden Co. Ltd.), Mini jack
(A mini plug should be prepared by users.)
LINK IN
: TCS6180-01-1010 (Hoshiden Co. Ltd.)
LINK OUT : TCS6180-01-1010 (Hoshiden Co. Ltd.)
8
7
6
5
4
3
2
1
RS-232C
Mini plug
EXT. IN
GND
8
7
6
5
4
3
2
1
EXT.IN
Werbung
Kapitel
Inhaltsverzeichnis
