With Manual Vernier Caliper - OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung

9.11.3

With manual vernier caliper

Fig. 58: Manual vernier caliper
Top: adjustable limit stop for well
Bottom: fixed limit stop for rim bead
1 Manual vernier caliper
2 Fixed limit stop
3 Insert for adhesive balance weight on rim bead
4 Ejector
5 Insert for adhesive balance weight in well
6 Millimeter scale
7 Knurled screw
8 Adjustable limit stop
Fastening the adhesive balance weight to the bead of
the rim
(ALU3 1st balancing plane and standard programs):
1. Put the adhesive balance weight in the insert for the
adhesive balance weight on the rim bead.
Fig. 59: Put the adhesive balance weight in the insert on the rim
bead
2. Position the fixed limit stop (2) on the bead of the
rim.
OMCN spa
Program structure | ROLL R8 (P-LOCK) | 99
3. Using the ejector (4), attach the adhesive balance
weight and push forwards to ensure firm adhesion.
Fig. 60: Example of application - rim bead
i
Use the plastic spatula to remove existing adhesive
balance weights.
Fastening the adhesive balance weight in the rim well
(ALU3 2nd balancing plane and ALU2, PAX2):
i
The position of the adhesive balance weight is
determined by dimension "J" of the balancing plane
previously established.
1. Place the required adhesive balance weight in the
insert for the adhesive balance weight in the rim
well (5).
Fig. 61: Place the adhesive balance weight in the insert in the
rim well
2. Position the adjustable limit stop (8) on the bead of
the rim.
3. Using the ejector (4), attach the adhesive balance
weight and push forwards to ensure firm adhesion.
Fig. 62: Attach the adhesive balance weight in the rim well
en
|
1 695 600 696 2016-09-30