OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 69

Pos. Designation
1 LCD monitor
2 Wheel-guard hood, moving
3 Wheel guard, fixed
4 Sonar
5 Rim-distance gauge
(electronic)
6 Cone of drive shaft
7 Laser
Lighting
8 Right pedal
9 Control panel
10 Shelf
11 Mains socket
12 On/Off switch
13 Internal sonar connection
14 Quick locking nut (mechanical)
15 Centering flange
16 Securing cone
17 Manual vernier caliper
18 Balance weight pliers
19 Measuring compass
20 Concave socket
21 Spacer ring
22 Rubber cap
23 Plastic spatula
24 USB connection
25 Wheel locking sleeve (pneumatic)
26 Centering flange with tie rod
27 Left pedal
28 Service unit with compressed air
connection
29 Clamping tool holders
OMCN spa
User information | ROLL R8 (P-LOCK) | 69
Function
Software display (measured values and operating instructions)
+ Protects operator against flying particles (e. g. dirt, water).
+ Starts and stops measurement)
Protects against flying particles (e.g. dirt, water).
Determines rim width by means of sonar.
+ Records rim distance and rim diameter.
+ Determines positions for attachment of adhesive balance weights.
Flange mounting
If the Easyfix® function is deactivated, the position of the adhesive balance weights
is indicated by a laser beam as soon as the correct balancing position is reached
Always switched on whenever the electronic rim-distance gauge is in use.
Blocks the shaft / wheel.
Operation ROLL R8 (P-LOCK)
+ Storage of cones and tools.
+ Shelf for balance weights and accessories.
Port for power supply cable.
Switching ROLL R8 (P-LOCK) on and off.
Internal sonar connection for attaching the sonar to the ROLL R8 (P-LOCK).
ROLL R8: Centers and secures wheel on the cone
ROLL R8: Centers and secures wheel on the cone
Centers wheel on flange shaft.
Used for manual measurement of the width and positioning of the adhesive balance
weights with the programs ALU2, ALU3, adhesive balance weight statics, PAX2.
Removes the wheel weights from the rims
Used for manual measurement of the rim width and the rim diameter.
For use with quick-action clamping nut with cone attached on the outside.
For use in combination with the quick-action clamping nut to secure the wheels if a
cone is used on the flange.
For protection when clamping aluminium rims.
For removing adhesive balance weights
For updating the software.
ROLL R8 P-LOCK: Centers and secures wheel on the cone
ROLL R8 P-LOCK: Centers and secures wheel on the cone
ROLL R8 P-LOCK:
+ Extension and retraction of tie rod
+ Transfer of rim data (optional).
ROLL R8 P-LOCK:
+ Checking/adjustment of operating pressure.
+ Removal of dirt.
+ Oil supply for compressed air system.
Storing accessories
en
|
1 695 600 696 2016-09-30