OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 85

8.2 Settings and service menu
Opens the diagnostics menu (for customer service only)
Opens the menu for standard adjustment and factory
adjustment (for customer service only)
Press <OK> to return to the previous page.
Settings for ROLL R8 (P-LOCK).
User-defined settings
Setting of resolutions and units
i
The following symbols are used in the selection
menu:
Automatic transfer (e. g. time)
Manual transfer (e. g. via pedal)
Function is deactivated
OMCN spa
Program structure | ROLL R8 (P-LOCK) | 85
8.2.1 Calibration
Calibration with wheel and test weight.
Flange calibration.
Press <OK> to return to the previous page.
Rim-distance gauge and sonar calibration.
8.2.2 Settings for
ROLL R8 (P-LOCK)
Activates or deactivates the printer.
*Accessories for ROLL R8 (P-LOCK)
Activates or deactivates the brake to lock the flange and
wheel in position.
Activates or deactivates the electronic rim-distance
gauge and the sonar.
Press <OK> to return to the previous page.
Transfer the position of the adhesive balance weight by
wait time or pedal click.
+ Positioning of adhesive balance weights with ALU2,
ALU3 and PAX2:
$ Setting PG:
Attachment with Easyfix® :
Laser beam 1) is deactivated and does not provide
assistance for attachment of the weight.
$ Setting P12, P3 or P18:
With the manual vernier caliper or without auxiliary
instruments:
Attach the weights in the positions 12, 3 or 18
o'clock;
The laser beam
tion (with turning wheel) and thus facilitates attach-
ment of the weight.
+ With all other programs and for all adhesive balance
weights, the balance weight must be attached in the
12 o'clock position!
Automatic selection of balancing program
+ Function for automatic recognition of the balancing
program is active.
+ Function for automatic recognition of the balancing
program is not active.
1) Depending on version, special accessory in some cases
1) illuminates on reaching the posi-
|
1 695 600 696 2016-09-30
en