Status Bar; Monitor Display - Omcn Roll R8 Sonar P-Lock Betriebsanleitung

en 82 | ROLL R8 (P-LOCK) | Operation
7. Operation
7.1 Start page
i
Switch on the ROLL R8 (P-LOCK) by means of
the on/off switch and wait approx. 1 min. for the
software to load; the Start page must appear before
ROLL R8 (P-LOCK) is ready to operate.
Fig. 34: Start page
The following menus can be selected on the Start page:
Symbol Designation Access to menu
Wheel Balancing program
balancing
Settings and Personal settings, calibration and
service customer service.
7.2

Monitor display

On the Start page, confirm entry to the Balancing menu
by pressing <OK>.
€
The main page of the Balancing program opens.
Fig. 35: Main page for wheel balancing

1 Status bar

2 Key area for quick access
3 Display area
4 Softkey bar
|
1 695 600 696 2016-09-30
7.2.1 Status bar
The following information is displayed depending on
the menu selected:
+
Current user.
+
Vehicle selected.
+
Balancing program selected.
+
Number of spokes on wheel by selecting "Split
program".
7.2.2 Key area for quick access
The information for the programmable function keys for
quick access is visualized in this area.
7.2.3 Display field
The following information is displayed here:
+
Rim data and positioning of
gauge
+
Information on positioning and mass of the balance
weights
7.2.4 Softkey bar
The softkey bar shows the functions available in the
corresponding menu. The functions are started by
pressing the function keys.
7.2.5 EXIT key
Symbol Item
Press <OK> to return to the previous
page.
Pressing this key terminates the menu selected and
returns to the previous page.
i
Values are stored only by pressing <OK>.
rim-distance
electronic
OMCN spa