OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 75

4.8 Attaching the moving wheel-guard
hood
1. Attach the bracket arm of the moving wheel-guard
hood to the ROLL R8 (P-LOCK) by means of the pin,
nut and screw.
2. Open and close the protective cover four times to
optimize movability and facilitate installation later.
1
2
Fig. 20: Attaching the wheel-guard hood
i
The supporting arm for the moving wheel-guard
hood for the sonar is fastened to the moving wheel-
guard hood by adhesive tape.
3. Remove the adhesive tape.
Fig. 21: Opening the adhesive tape
OMCN spa
651113-25_BM
x4
Initial commissioning | ROLL R8 (P-LOCK) | 75
4. Attach the supporting arm to the sonar.
!
During installation, the sonar arm must remain
completely lowered in its stop position. The driver
rod must neither lift nor move it. Ignoring these
instructions can impair the sonar sensor's efficiency.
i
Be sure to install the provided rubber ring between
the supporting arm and sonar and to fasten the
retaining ring at the left of the supporting arm.
Fig. 22: Fastening the supporting arm to the sonar
4.9 Mounting the cone holder
i
The screws for fastening the cone holder are already
attached to the ROLL R8 (P-LOCK).
€
Mount the cone holder as shown in the figure.
en
|
1 695 600 696 2016-09-30