OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 73

4.5 Attaching the wheel-guard hood
i
The screws for fastening the wheel-guard hood are
already attached to the support.
1. Loosen the screws used for fastening the support.
2. Attach the wheel-guard hood to the support.
Fig. 14: Attaching the wheel-guard hood
4.6 Attaching the monitor
i
The screws for fastening the monitor arm are already
attached to the ROLL R8 (P-LOCK).
i
Before the monitor can be attached, the connection
cables must be installed.
1. Loosen the screws for attaching the monitor arm.
2. Install power supply cable and VGA connection
cable in the monitor arm.
Fig. 15: Installing the connection cables
OMCN spa
Initial commissioning | ROLL R8 (P-LOCK) | 73
3. Attach the monitor arm to the ROLL R8 (P-LOCK).
Fig. 16: Attaching the monitor arm
4. Attach the monitor to the monitor arm.
5. Connect the power supply cable and VGA
connection cable to the monitor.
Fig. 17: Attaching the monitor
en
|
1 695 600 696 2016-09-30