OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 71

WARNING – Defective or incorrectly
attached hoisting straps!
Risk of injury due to falling ROLL R8 (P-LOCK).
€
Check hoisting straps for physical damage
before attaching.
€
Tighten lifting straps uniformly.
€
Carefully lift the ROLL R8 (P-LOCK).
5. Use a crane to lift the ROLL R8 (P-LOCK). Set up
the unit in the intended area, paying attention to the
specified minimum distances.
i For safe and ergonomic operation, it is advisable
to set up the ROLL R8 (P-LOCK) at a distance of
500 mm from the nearest wall.
500 mm
Fig. 8: Minimum clearances
OMCN spa
Initial commissioning | ROLL R8 (P-LOCK) | 71
4.3 Attaching the
ROLL R8 (P-LOCK)
Warning - danger of tilting!
Considerable forces are involved in the wheel
balancing process.
€
Before the equipment is used, it is
essential to fasten it to the floor according
to the manufacturer's instructions.
1. Set up the ROLL R8 (P-LOCK) on the floor at the
intended final location and determine the references
for the holes in the base of the ROLL R8 (P-LOCK).
Fig. 9: Overview of mounting holes
2. Mount a 14 mm bit on the drill and drill a 65 mm
deep hole.
!
We recommend that you clean the hole carefully
before inserting the plug.
en
|
1 695 600 696 2016-09-30