Initial Commissioning - OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung

en 70 | ROLL R8 (P-LOCK) | Initial commissioning
4.

Initial commissioning

4.1 Unpacking the
ROLL R8 (P-LOCK)
1. Remove the steel band and fasteners.
2. Carefully lift off the packaging.
3. Remove the accessories and packaging material
from the packaging unit.
i
Check that the ROLL R8 (P-LOCK) and the
accessories are in proper working order and that
there are no visible signs of component damage.
In case of doubt, do not commission the unit and
consult customer service.
i
Dispose of the packaging material at an appropriate
collection site.
4.2 Setting up the
ROLL R8 (P-LOCK)
i
On delivery, the ROLL R8 (P-LOCK) is fastened to
the wooden pallet with screws.
Fig. 5: ROLL R8 (P-LOCK) on pallet
|
1 695 600 696 2016-09-30
1. Loosen the 3 screws, with which the
ROLL R8 (P-LOCK) has been fixed on the pallet;
2. Remove the plastic plug of the machine.
3. Place the eyebolts into the extensions.
651113-10_BM
Fig. 6: Preparation and installation of lifting points
4. Insert suitable straps (n°2 x length = 1 meter; n°1
x length = 2 meters), with sufficient load-bearing
capacity (load-bearing capacity=1000 kg; color
purple), as shown in the figure.
Fig. 7: Lifting the ROLL R8 (P-LOCK)
OMCN spa