Program Structure - OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung

en 84 | ROLL R8 (P-LOCK) | Program structure
To continue, confirm by pressing the <OK> key.
2. Open the "User-defined settings" menu by pressing
v v
< >< > and <OK>.
3. Select the "Quick-access key assignment" menu.
To continue, confirm by pressing the <OK> key.
4. Use the arrow keys vz to select the quick-access
key required.
5. Use the arrow keys ou to select the required
assignment (function) and assign the function to the
quick-access key with <OK>.
i
The quick-access key is displayed together with the
function selected.
6. Repeat steps 4 and 5 for the other quick-access keys.
"
The assignment (function) of the quick-access keys
can be altered by the user at any time.
|
1 695 600 696 2016-09-30
8.

Program structure

8.1 Balancing menu
To continue, confirm by pressing the <OK> key.
i
To display the software version and firmware version
on this page, press the
i
To display the number of daily measuring cycles on
this page, press the
Selection of user 1, 2 or 3. The last settings and rim data
selected are assigned to the current user and stored.
Selection of type of vehicle (passenger car or
motorcycle); the type of vehicle selected is displayed in
the status bar.
Opens the "Enter rim data" menu.
Selection of balancing program; 11 passenger car
programs, 5 motorcycle programs; the program selected
is displayed in the status bar.
Press <OK> to return to the previous page.
Displays the exact, non-rounded imbalance value
measured.
Selection of the number of spokes.
The weights can be distributed behind the spokes after
the imbalance is measured.
Opens the "Imbalance minimization" program.
"Printer menu" *only present if the printer is activated.
ou and v
keys.
ou and v
keys.
OMCN spa