OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 91

2. Position the electronic rim-distance gauge at the 2nd
measuring point (without bringing the electronic rim-
distance gauge into the rest position beforehand)
and hold in this position for 1 second.
Fig. 42: 2nd measuring point and 2nd balancing plane for ALU3
2nd measuring point and 1st balancing plane for ALU2
« An audible signal sounds to confirm storage of
the position.
i
If the electronic rim-distance gauge is put back in
the rest position, the ALU3 balancing program is
selected automatically. Continue with step 3 for
ALU2.
OMCN spa
ALU3
ALU2
Program structure | ROLL R8 (P-LOCK) | 91
3. Position the electronic rim-distance gauge at the 3rd
measuring point (without bringing the electronic rim-
distance gauge into the rest position beforehand)
and hold in this position for 1 second.
Fig. 43: 3rd measuring point and 2nd balancing plane for ALU2
« An audible signal sounds to confirm storage of
the position.
i
If the electronic rim-distance gauge is put back in
the rest position, the ALU2 balancing program is
selected automatically.
en
ALU2
|
1 695 600 696 2016-09-30