OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 101

Phase 6: Further rotating of tire on rim
1. Rotate the wheel until a green rectangle appears.
2. Make double reference mark on the tire (at 12
o'clock position).
Fig. 64: Double reference mark at 12 o'clock
3. Press <OK> .
4. Remove wheel from the flange.
i
To rotate the tire on the rim, it may be necessary to
deflate the tire, unseat it again (using a tire changing
machine) and then re-inflate after rotating.
5. Rotate the tire on the rim 180 degrees.
i
The mark previously made provides a guide.
Phase 7: Storing the new position
1. Fasten wheel.
2. Rotate the valve to the 12 o'clock position.
3. Press <OK> .
« The new position of the wheel on the flange is
stored.
OMCN spa
Imbalance minimization | ROLL R8 (P-LOCK) | 101
Phase 8: 2nd reference measurement
1. Close the wheel-guard hood.
« Measurement commences.
i
To rotate the tire on the rim, it may be necessary to
deflate the tire, unseat it again (using a tire changing
machine) and then re-inflate after rotating.
i
If the test run is to be repeated, the monitor displays
an appropriate message. In this case, continue again
with minimization (PHASE 5 onwards).
"
On completion of the test run, the imbalance is
automatically compared to the minimum residual
imbalance. If the difference between these two values
is below the maximum permissible level, the tire and
rim are optimally matched.
2. Press <OK> .
« Return to "main page".
i
If the test run is not properly completed, the
entire procedure (starting with PHASE 1) must be
repeated.
3. Press <OK> .
"
Return to "main page".
en
|
1 695 600 696 2016-09-30