Alu2 (Pax2), Alu3 - OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung

en 94 | ROLL R8 (P-LOCK) | Program structure
Rim width
1. Open the "Enter rim data" menu on the main page
of the balancing software.
2. Position the measuring compass as shown in the
figure.
Fig. 48: Determining rim data with a measuring compass
1 Rim width scale
2 Inner tip for rim width
3. Read off the rim width.
4. Enter the value for the rim width that has been read
off by using the keys <-> or <+> for the rim width
in the unit "inch".
i
For several rim types, the rim diameter must be
entered in "mm" (for conversion from inches to
millimeters and vice-versa see section "Rim data
menu").
"
All the necessary rim data have been recorded.
9.6.2

ALU2 (PAX2), ALU3

Distance and rim diameter
Identical to the manual measurement for the balancing
programs "Standard, ALU1, ALU4, ALU5, PAX1 and all
static balancing programs".
Rim width (distance between the two balancing
planes)
i
The rim width (distance between the two balancing
planes) can be determined in the balancing
programs Alu2, Alu3 and Pax2 and the adhesive
balance weights easily positioned and fastened
using the manual vernier caliper.
|
1 695 600 696 2016-09-30
1. Open the "Enter rim data" menu on the main page
of the balancing software.
2. Select balancing program.
3. Position the adjustable limit stop (8) of the manual
vernier caliper on the bead of the rim.
Fig. 49: Manual vernier caliper
1 Manual vernier caliper
2 Fixed limit stop
3 Insert for adhesive balance weight on rim bead
4. Ejector
5 Insert for adhesive balance weight in well
6 Millimeter scale
7 Knurled screw
8 Adjustable limit stop
4. Put the insert for the adhesive balance weight in the
well (5) at the position where the balance weight is
to be attached.
Fig. 50: Positioning the "adhesive balance weight in the well"
5. Tighten the knurled screw (7) to block the position
determined.
6. Read off the value "J" on the millimeter scale.
7. Enter the rim width that has been determined in the
unit "mm" by using the keys <-> or <+> for the rim
distance .
"
All the necessary rim data have been recorded.
OMCN spa