OMCN ROLL R8 SONAR P-LOCK Betriebsanleitung Seite 72

en 72 | ROLL R8 (P-LOCK) | Initial commissioning
3. The ROLL R8 (P-LOCK) must be fastened to the floor
at 3 points by means screws and plugs and then
adjusted via the adjustment screw.
Fig. 10: Attaching the ROLL R8 (P-LOCK)
1 Adjustment screw
2 Fastening screws
3 Bracket
4. Insert the supplied plug, insert the washers in-
between and, using a torque wrench, fully tighten to
a torque of 25 N*m.
i
After setting up the ROLL R8 (P-LOCK) proceed as
follows:
$
Remove the threaded lug.
$
Re-insert the dummy plug in the balance weight
storage shelf.
$
Remove the bolt and nut from the shaft (wheel
guard).
|
1 695 600 696 2016-09-30
4.4 Mounting the support for the wheel-
guard hood and sonar
i
The sonar is pre-installed on the support for
the wheel-guard hood. The screws for fastening
the support are already attached to the
ROLL R8 (P-LOCK).
1. Loosen the screws used for fastening the support at
least 5 mm so that the support can be installed.
Fig. 11: Loosening the screws at least 5 mm
2. Place support over the screws and press down.
Fig. 12: Placing the support over the screws
3. Tighten screws so that the support is fastened
securely to the ROLL R8 (P-LOCK).
4. Attach potentiometer connection cable (see fig.)
Fig. 13: Routing the potentiometer connection cable
OMCN spa