3M Clean-Trace NG Benutzerhandbuch Seite 6

(English)
this shows the battery pack removed. note the battery contacts. Do not touch or contaminate them as this could lead to unreliable operation. the
battery pack is only available from 3M or local distributor.
2.04 Switching the Instrument ON
ensure that no samples have been left in the chamber from previous tests before switching the instrument on. the power switch is the red button on
the instrument. Pressing and holding the on/off button will switch the 3M clean-trace nG Luminometer on. Pressing and holding the on/off button
again will switch the 3M clean-trace nG Luminometer off. When switching on, the 3M clean-trace nG Luminometer performs a series of self-checks,
including an initial instrument background measurement and a calibration check. the following screens will be displayed.
During initial startup and system self check.
the instrument then initializes and the following screen is displayed:
It is possible to pause the 3M clean-trace nG Luminometer at this point in order to note the hardware and software versions to aid diagnosis in the
event of a malfunction. Press any button while this screen is displayed and the instrument will pause.
the version numbers are displayed at the bottom of the screen.
Press any button to allow the 3M clean-trace nG Luminometer to continue.
4