Instrument Overview; On/Off Switch - 3M Clean-Trace NG Benutzerhandbuch

2.0 INSTRUMENT OVERVIEW

2.01 Parts of the 3M Clean-Trace NG Luminometer
the purpose of each of the Function Buttons can change according to the menu screen being displayed. once a menu is selected the button functions
will be displayed at the bottom of the screen directly above each button.
2.02 General Features
the 3M clean-trace nG Luminometer is a light-weight, fully portable instrument with alphanumeric LcD display. the instrument is for use in
production areas and laboratories and can be supplied with a carrying pouch. A separate internal Lithium Battery is used to retain information in the
instruments memory, with regard to sample plans, test points, data and calibration setting.
2.03 Charging the battery
the instrument runs on a removable, rechargeable Lithium Ion battery. the sealed battery pack is supplied with the 3M clean-trace nG Luminometer
and needs to be charged prior to use.
It is necessary to attach the battery pack to the instrument. Locate the battery pack into the aperture in the rear of the 3M clean-trace nG
Luminometer by inserting the bottom of the battery pack first and pushing the battery into place. secure the battery pack by turning the fixing screw
clockwise using a small screwdriver. Do not over-tighten.
the 3M clean-trace nG Luminometer may now be charged using the charger supplied. Plug the connector from the charger into the 3M clean-trace
nG Luminometer, then connect the charger to an Ac power outlet and switch on. Alternatively, the optional docking station is used, insert the 3M
clean-trace nG Luminometer into the docking station, plug the connector from the charger into the docking station then connect the charger to an Ac
power outlet.
the battery in the 3M clean-trace nG Luminometer will charge fully in approximately 2 hours and will then be ready for use. the battery level
indicator shows the state of charge. remove the Ac power and unplug the charger from the instrument. If a docking station is used, this can remain
attached to the charger so that, when in docking station, the instrument is always being charged ready for use.
chamber cap
cap release
Battery level indicator
Display screen
Function buttons
cursor control

on/off switch

rs232 to Pc
usB to Pc (V2 only)
Power from charger
Figure 2
2
(English)