Herunterladen Inhalt Inhalt Diese Seite drucken

Establishing A Connection Between The Orthosis And C-Soft - Ottobock C-Brace Gebrauchsanweisung

Vorschau ausblenden Andere Handbücher für C-Brace:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

► Double-click the existing job.
Entering the Password
The password input screen is displayed after starting the Ottobock Data Station > C-Soft.
INFORMATION
Unlock PIN: This code is valid on any computer.
Personal password: This code is only valid on the computer on which it was entered/changed.
INFORMATION
If certification for the C-Leg has been obtained, the username is not valid for the orthosis fitting. Only by entering
the username for the orthosis fitting will the C-Soft version for the orthotic system be available.
The certification for the C-Leg cannot be used for the orthotic system. An error message is therefore displayed
when establishing a connection.
INFORMATION
To switch from the C-Leg fitting to the orthosis fitting, close the Ottobock Data Station, restart it and enter the
username for the orthosis fitting.

7.6.2 Establishing a connection between the orthosis and C-Soft

INFORMATION
Observe the following points:
• The 60X5 BionicLink PC is connected to the PC being used and the corresponding drivers are installed.
• The 60X7 BionicLink is connected to the orthosis.
• The orthosis battery is charged (the blue LED on the 60X7 BionicLink is lit up or flashing).
• The battery charger is not connected to the orthosis.
INFORMATION
The range of the Bluetooth connection is around 10 metres, but this can vary depending on local conditions. The
orthosis should not be taken outside of this range while it is connected.
After entering the password, the Connect tab is displayed automatically.
C-Brace
The first time the password is entered, the username and the unlock PIN that was
provided within the scope of previous successful certification for the orthosis fitting
must be entered.
INFORMATION: Observe uppercase/lowercase letters.
After entering the unlock PIN, another password entry screen is displayed to enter
and confirm a personal password (chosen by the software user). This password
then replaces the unlock PIN.
INFORMATION: Observe uppercase/lowercase letters.
1) Click the Connect via Bluetooth button to establish a Bluetooth connection
between C-Soft and the orthosis.
INFORMATION: When several orthoses are present, select the desired Bion­
icLink device in the Bluetooth device selection window according to the informa­
tion on the reverse side of the device. If only one BionicLink device is available,
the selection will be skipped automatically.
2) Read the security notice on the screen and click the OK button.
3) A connection is established to the orthosis.
Adjustment with Ottobock C-Soft
Ottobock | 59

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis