Yamaha DSP-Z9 Bedienungsanleitung Seite 87

■ Macro operations
MACRO
TRANSMIT RE-NAME CLEAR LEARN MACRO OFF
SYSTEM
POWER STANDBY V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
MULTI CH IN
PURE DIRECT
TITLE
1
Set MACRO ON/OFF to ON.
2
Press a macro button.
Notes
• When you have finished using the macro feature, set MACRO
ON/OFF to OFF.
• While the remote is carrying out a macro program, it will not
accept any other button's function until the macro operation is
complete (the TRANSMIT indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
■ Programming macro operations
You can program your own macros and use the macro
feature to transmit several remote control commands in
sequence at the press of a button. Be sure to set up
manufacturer codes or perform learning operations before
programming the macro. We do not recommend
programming continuous operations such as volume
control in a macro.
Notes
• The default macro is not cleared when a new macro is
programmed for a button. The default macro can be used again
when the programmed macro is cleared.
• It is not possible to add a new signal (macro step) to the default
macro. Programming a macro changes all macro contents.
1
Press MACRO using a ballpoint pen or
similar object.
"MCR ?" appears in the display window.
MACRO
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press MACRO again.
MACRO
ON MACRO ON/OFF
Macro buttons
2
Press the macro button you want to use to
operate the macro.
The macro button name and the selected component
name appear alternately in the display window.
V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
Notes
• "AGAIN" appears in the display window if you press a button other
than a macro button.
• To change the selected source component, press SOURCE SELECT
k/n. Pressing the input selector buttons will program a macro step,
whereas SOURCE SELECT k/n only changes the selected
component and corresponding component control area.
3
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, "FULL" appears and the remote
control automatically exits from the macro mode.
SYSTEM
POWER STANDBY V-AUX TUNER
CABLE SAT MD/TAPE CD-R
DTV/LD VCR 1 VCR 2 DVR
PURE DIRECT
TITLE
ENTER
SOURCE
INPUT MODE TOP
DISPLAY MENU
SELECT –
SEARCH CHAPTER
POWER REC STOP PAUSE
Flashes alternately so you can
set the next step
Note
"NG" appears in the display window if programming was
unsuccessful. In this case, start over from step 2.
REMOTE CONTROL FEATURES
Flashes alternately
PHONO
CD
DVD
MULTI CH IN
EXIT
SOUND
+
1
MCR 1: DVD a
PLAY
MCR 2: DVD h
2
Indicates the
number of macro
steps entered
85