Yamaha DSP-Z9 Bedienungsanleitung Seite 40

PLAYBACK
7
Select a sound field program if desired.
Press DSP PROGRAM then rotate MULTI JOG (or
on the remote control, set 10KEY/AMP to AMP, then
press one of the sound field program buttons
repeatedly) to select a sound field program. (See
page 48 for details about sound field programs.)
MULTI JOG
DSP
PROGRAM
Front panel
Note
When this unit detects Dolby Digital signals, the following
display appears for a few seconds. This shows how the signal
level is being corrected to become –27 dB (THX
recommendation).
DialNorm;;+4dB
To listen with headphones (SILENT CINEMA)
The SILENT CINEMA mode allows you to enjoy multi-
channel music or movie sound, including Dolby Digital
and DTS surround, through ordinary headphones.
SILENT CINEMA activates automatically whenever you
connect headphones to the PHONES jack while listening
to CINEMA DSP or HiFi DSP sound field programs. The
"SILENT CINEMA" indicator lights up on the front panel
display. (If the sound field programs are off, you listen
with normal stereo reproduction.)
38
10KEY AMP STEREO HALL#1 HALL#2 CHURCH
1 2 3 4
or
JAZZ ROCK MUSIC ENTERTAIN
5 6 7 8
6.1/5.1 MOVIE THX /DTS NIGHT
9 0 +10 +100
CHP/INDEX
Remote control
To adjust the tone
You can adjust the bass/treble
balance for the front left/right,
center and subwoofer channels.
Press TONE CONTROL
repeatedly on the front panel to
select Treble or Bass.
Select Treble, then rotate MULTI JOG to the right or left
to increase or decrease the high-frequency response.
Select Bass, then rotate MULTI JOG to the right or left to
increase or decrease the low-frequency response.
To cancel the tone control, press TONE CONTROL
repeatedly to select OFF.
Notes
• If you increase or decrease the high-frequency or low-frequency
sound to an extreme level, the tonal quality of the surround
speakers may not match that of the front left/right and center
speakers.
• TONE CONTROL is not effective when:
– The THX (page 48) or DIRECT STEREO (page 43) program
is selected.
– PURE DIRECT is selected.
• If headphones are connected to this unit, the Tone Control
setting adjusts the bass/treble balance of your headphones
(page 62).
To mute the sound
Press MUTE on the remote control.
"MUTE" blinks in the front panel display.
To resume the audio output, press MUTE
again (or press VOLUME +/–). "MUTE" disappears from
the display.
y
• You can adjust the muting level (see page 64).
• You can also perform this operation using the GUI remote
control (see page 29).
MULTI JOG
TONE
CONTROL
MUTE