Zone 2; Zone 2 Connections - Yamaha DSP-Z9 Bedienungsanleitung

This unit allows you to configure a multi-room audio-video system. The Zone 2 feature enables you to set this unit to
reproduce separate input sources in the main room and second room (Zone 2) using the supplied remote control from the
second room.

Zone 2 connections

You need the following additional equipment to use this unit's multi-room functions:
• An amplifier and speakers for the second room.
• A video monitor for the second room.
OUT IN OUT
■ System configuration and connection example
Using external amplifiers
To use an external amplifier in Zone 2, select External in ZONE2 AMP.
DVD player
(or other component)
Notes
• When not using the main room, turn down the volume of this unit in the main room. Adjust the Zone 2 volume using the amplifier in
the second room.
• To avoid unexpected noise, DO NOT USE the Zone 2 feature with CDs encoded in DTS.
• Dolby Digital RF signals and signals input through an i.LINK connection are not output from ZONE 2 COAXIAL OUT. Further, the
Zone 2 volume setting does not apply to signals output from ZONE 2 COAXIAL OUT (i.e., input signals are output at the same
volume they are input).

ZONE 2

REMOTE
IN
CONTROL OUT
This unit
This unit
DVD INPUT
Infrared emitter
Main room
REMOTE CONTROL OUT
y
• Since there are a number of ways you can connect and use this
unit in a multi-room installation, we recommend that you
consult your nearest authorized YAMAHA dealer or service
center for the Zone 2 connections that best meet your
requirements.
• Some YAMAHA models are able to connect directly to this
unit's REMOTE CONTROL OUT jack. If you own these types
of products, you may not need to use an infrared emitter. Up to
6 YAMAHA components can be connected as shown here.
ZONE 2 VIDEO OUT
ZONE 2 AUDIO OUT or
ZONE 2 COAXIAL OUT
Amplifier Video
monitor
Remote control
Infrared signal
receiver
Second room
ZONE 2 REMOTE IN
ZONE 2
93