Changing Source Names In The Display Window - Yamaha DSP-Z9 Bedienungsanleitung

6
Press and hold the button you want to
program on the remote control for your
component until "OK" appears in the display
window.
Notes
• "NG" appears in the display window if programming was
unsuccessful. In this case, start over from step 5.
• This remote control can learn approximately 120 functions.
However depending on the signals learned, "FULL" may
appear in the display before you have programmed 120
functions. In this case, clear unnecessary programmed functions
to make room for further learning.
7
Repeat steps 5 and 6 to program additional
functions.
8
Press LEARN again to exit from the learning
mode.
LEARN
Notes
• Learning may not be possible in the following cases:
– When the batteries in the remote control for this unit or other
components are weak.
– When the distance between the two remote controls is too
great or too small.
– When the remote control infrared windows are not aimed at
an appropriate angle.
– When the remote control is exposed to direct sunlight.
– When the function to be programmed is continuous or
uncommon.
• "ERROR" appears in the display window if you press more than
one button at the same time.
Changing source names in the
display window
You can change the name that appears in the display
window on the remote control if you want to use a
different name to the one that is factory preset. This is
useful when you have set the input selector to control
another component.
1
Press an input selector button to select the
source component you want to rename.
The selected component name appears in the display
window.
V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
2
Press RE-NAME using a
ballpoint pen or similar
object.
3
Press k/n to select and enter a character.
Pressing n changes the character as follows:
A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash).
(Pressing k changes the characters in reverse order.)
ENTER
4
Press l / h to move the cursor to the next
position.
ENTER
y
If you want to continue setting up names for other
components, press ENTER and repeat steps 1, 3 and 4.
5
Press RE-NAME again to exit from the
renaming mode.
RE-NAME
REMOTE CONTROL FEATURES
RE-NAME
83