Sdo-Abbruch-Code - IFM Electronic CR1083 Handbuch

ifm Programmierhandbuch ecomatmobile
Anhang
>

SDO-Abbruch-Code

Der SDO-Abbruch-Code gehört NICHT zum Emergency-Telegramm!
Abbruch-Cod
Beschreibung
e [hex]
0503 0000 toggle bit not alternated
0504 0000 SDO protocol timed out
0504 0001 client/server command specifier not valid or unknown
0504 0002 invalid block size (block mode only)
0504 0003 invalid sequence number (block mode only)
0504 0004 CRC error (block mode only)
0504 0005 out of memory
0601 0000 unsupported access to an object
0601 0001 attempt to read a write only object
0601 0002 attempt to write a read only object
0602 0000 object does not exist in the object dictionary
0604 0041 object cannot be mapped to the PDO
0604 0042 the number and length of the objects to be mapped would exceed PDO length
0604 0043 general parameter incompatibility reason
0604 0047 general internal incompatibility in the device
0606 0000 access failed due to an hardware error
0607 0010 data type does not match, length of service parameter does not match
0607 0012 data type does not match, length of service parameter too high
0607 0013 data type does not match, length of service parameter too low
0609 0011 sub-index does not exist
0609 0030 value range of parameter exceeded (only for write access)
0609 0031 value of parameter written too high
0609 0032 value of parameter written too low
0609 0036 maximum value is less than minimum value
0800 0000 general error
0800 0020 data cannot be transferred or stored to the application
0800 0021 data cannot be transferred or stored to the application because of local control
0800 0022 data cannot be transferred or stored to the application because of the present device state
object dictionary dynamic generation fails or no object dictionary is present
0800 0023
(e.g. object dictionary is generated from file and generation fails because of an file error)
PDM360 NG (CR1083, CR1087) V02.03.xx 2017-01-18
CANopen-Tabellen
9970
355