Control Panel Arm Rest - Kärcher MC 130 Bedienungsanleitung

5.12.2.1 Display work mode
1 Motor speed
2 Control drive of the attachment in the front in %
3 Symbol: Turtle (indication with transport mode fast)
4 Symbol: Snail (indication with transport mode slow)
5 Symbol: motor operating hours
6 Operating hours meter for motor
7 Symbol: Working hours (no function)
8 Working hours counter
9 Working speed
10 Mileage
11 Date / time
12 Direction of travel reverse
13 Forward travel direction
14 Control drive of the attachment in the back in %
15 Filament symbol : Pre-heat
16 Coolant temperature motor
17 Warning lamp for battery charge indicator
18 Warning light motor oil pressure
19 Warning light parking brake operated
20 Temperature of hydraulic oil
21 Tank indicator
5.12.3 Display symbols (complete)
Display symbols and warning indicators that have not been
described yet are listed below. During operation, they are
not all on at the same time.
5.12.4 Depressurizing the hydraulic system
(pressure relief)
In order to disconnect the hydraulic hoses from the hydrau-
lic connections, the hydraulic system must be depressur-
ised first.
Unplug the signal connector for attachment recognition

(front).
Turn on the ignition - do not start the motor.

Switch on PTO (on control panel of the arm rest).

Push the function key F 10 on the display, then function

key F 6. The hydraulic system is depressurised.
Loosen the hydraulic hose.

The attach can be removed. Proceed in reverse order

for installation.

5.13 Control panel arm rest

The control panel is located on the left arm rest of the driv-
er seat. The arm rest can be adjusted to the driver individ-
ually, see Chapter "Adjusting the driver seat".
For left-hand drive vehicles e.g. for UK: The control
panel is located on the right arm rest of the driver's seat.
5.13.1 Setting the sweeping parameters
A Save button
press to save the set values
B Rotary knob
turn to change the values
C button, left and right side brush speed
With individual lifting (option), button left side brush speed
D With individual lifting (option), button right side brush
speed
E With individual lifting (option), button contact pressure
right side brush
F Motor rpm
push to set the values
Note
The suction performance depends on the selected mo-
tor speed.
1600 1/min - for light waste
2200 1/min - for normal soiling
2500 1/min - for severe, heavy soiling
G Button, contact pressure left and right side brush
With individual lifting (option), button contact pressure
left side brush
To change the values, switch on PTO.

Press button C, F or G. The settings appear on the display.

Select the desired value with the rotary knob (B).

Push the safe button (A) to save the value.

15
-
EN 67