Hydraulic Valve Emergency Control En; Driver Cabin En - Kärcher MC 130 Bedienungsanleitung

5.5.2 Switch lever (version 2)
The switching valve is located at the front of the transport
vehicle.
1 Switch lever in "waste container" position
2 Switch lever in "Attachment frame tilting" position
To empty the waste container: Set the switch lever to

the "Waste container" position.
To raise the attachment frame: Set the switch lever to

the "Attachment frame tilting" position.
Note
Use the attachment frame only if the waste container is
completely lowered!
5.6 Hydraulic valve emergency control
The hydraulic valve emergency control is located behind a
cover on the outside of the driver cabin.
The hydraulic valve emergency control is required for the
following tasks:
Raising the waste container/attachment frame if the de-
–
vice hydraulics failed, for example, due to a failure of
the motor
Raising the front power lift/suction mouth if the device
–
hydraulics failed, for example, due to a failure of the
motor
Releasing the spring load of the parking brake, e.g for
–
towing the vehicle
62
Figure: Hydraulic valve emergency control in the home po-
sition (normal operation) ball tap in vertical position and all
knurled thumb screws unscrewed.
1 Hand pump
Note
A hand pipe is required to operate the manual pump, it
is located in the driver cabin laterally behind the driver
seat.
2 Ball tap
A Knurled head screw
B Knurled head screw
C Knurled head screw
D Knurled head screw
E Knurled head screw
F Knurled head screw
Unlock 3 screws by a counterclockwise rotation and re-

move the cover.
5.6.1 Raising the waste container/attachment
frame
Screw in the knurled thumb screw (B, E, F).

Operate the manual pump (1) to raise the waste con-

tainer or attachment frame.
Slowly unscrew the knurled thumb screw (F) to lower

the waste container or attachment frame.
Unscrew the knurled thumb screws again for activation

(home position).
5.6.2 Raising front power lift/suction mouth
Screw in the knurled thumb screw (A, D, F).

Operate the manual pump (1) to raise the front power

lift or suction mouth.
Slowly unscrew the knurled thumb screw (F) to lower

the front power lift or suction mouth.
Unscrew the knurled thumb screws again for activation

(home position).
5.6.3 Releasing the spring load of the parking
brake
Turn the ball tap (2) to the horizontal position.

Screw in the knurled thumb screw (C).

Operate the manual pump (1) to release the spring

load.
Bring the ball tap in the vertical position and unscrew

the knurled thumb screw (C) to activate the spring load
(home position).
5.7 Driver cabin
5.7.1 Driver's door/passenger door
The driver's door is on the right side in the direction of trav-
el, the passenger door or emergency exit on the left.
For left-hand drive vehicles e.g. for UK: The driver's
door is located at the left side in the travel direction. Pas-
senger door and emergency exit are on the right side.
The driver's door and passenger door can be locked.
Lock both doors after parking the vehicle.

10
-
EN