Scheppach HS730 Originalbetriebsanleitung Seite 21

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We wish you much joy and success in working with
your new appliance.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly re-
pairs, reduce downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu-
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
The machine can only be operated by persons who were
instructed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
In addition to the safety instructions contained in this
operating manual and the specific regulations of your
country, the technical rules generally accepted for the
operation of machines of the same type must be ob-
served.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
2. Layout (fig. 1 - 2)
1. Motor with frame
2. Feed rocker
3. Saw blade cover, outer
4. Saw blade cover, inner
5. Swivel bracket
6. Frame
7. Mounting hole
8. Cross member
9. Return spring
10. Handle
11. Plastic liner
12. Travel fixture
13. Saw blade locking mechanism
14. Plug combination/ on-off switch
15. Motor plate
16. Guard
17. Wood support
18. Locking level
19. Wheel axle
3. General notes
• Swivel log saw
• Axle
• Tools
• Equipment pack
• User's manual
4. Intended use
The machine corresponds to the valid EC guideline.
• The log saw is constructed as 1-man-operating
stand and is only to be used in outdoor locations.
• The log saw is a portable circular saw. It is only ap-
plicable to cross cut firewood with a feeding rocker
according to the technical specifications.
www.scheppach.com GB | 21