Auto Shutdown Protection; Residual Heating Warning; Heat Settings - Klarstein Controlsync Bedienungsanleitung

Using your Induction Hob To Start Cooking
After power on, the buzzer beeps once, all the indicators light up for
1 second then go out, indicating that the hob has entered the state of
standby mode.
1. Place a suitable pan on the cooking zone that you wish to use. Make
sure the bottom of the pan and the surface of the cooking zone is
clean and dry.
2. Choose the right knob of the heating zone ,Turn the knob clockwise
to start the induction hob,an number tube on hob will flash 3S,and then display the
right gear your choose.
When you have finished cooking
Turn the knob counter clockwise to zero position to close the induction hob.
Beware of hot surface
'H' will show which means cooking zone is too hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an energy saving
function if you want to heat further pans, use the hotplate that is still hot.

AUTO SHUTDOWN PROTECTION

Auto shutdown is a safety protection function for your induction hob. This occurs
whenever you forget to switch off a cooking zone. The default shutdown times are
shown in the table below:
Power level
Default working time (hour)
When the pot is removed, the induction hob can stop heating immediately and the hob
automatically switch off after 1 minute.

RESIDUAL HEATING WARNING

When the hob has been operating for some time, there will be some residual heat. The
letter 'H' appears to warn you to keep away from it.

Heat settings

1 2 3 4
8 8 8 4
5 6 7 8
4 4 2 2
EN
9
2
45