Klarstein CONTROLSYNC Bedienungsanleitung Seite 116

EN
E7/E8
E9
EA
EB
52
Socket not connected
or loose
Sensor cable is
disconnected / poorly
Pot sensor open/
riveted
short-circuit
Chip detection fault:
open circuit or poor
welding of copper
sheet
The fan does not
rotate or the speed
is slow: both furnace
have fault codes after
operating for a period
of time
High temperature
protection of pot
sensor
Furnace Plate
Sensor Fault: Always
High Temperature
Resistance
Drive board fault:
fault code of a single
furnace
Pot sensor Furnace Plate Sensor
removal or failure Fault: Temperature
protection Sensor Inoperative
Communication
Communication line
fault: Power board
problem: neither
fails to receive
furnace can be heated
display board
or uncontrolled
signal
Reconnect the furnace
tray sensor
Replace the furnace tray
sensor
Replace the drive board
1. Fan socket loose:
reconnect
2. Fan failure: replace
the fan
3. No power output for
filter board fan: replace
filter board
4. Display board has no
fan drive signal: replace
the display board
Replace the furnace tray
sensor
Replace the drive board
Replace the furnace tray
sensor
Replace the display
board: the connection
between the display
board and the drive
board is poor