Troubleshooting - Klarstein Controlsync Bedienungsanleitung

Spillovers on the
touch control

TROUBLESHOOTING

Problem
The hob cannot be
turned on.
The touch controls
are unresponsive.
The touch controls
are difficult to
operate.
The glass is being
scratched.
Some pans make
crackling or clicking
noises.
Switch the power to the
hob off.
Soak up the spill.
Wipe the touch control area
with a clean damp sponge
or cloth.
Wipe the area completely
dry with a paper towel.
Switch the power to the
hob back on.
Possible causes
No power.
The controls are locked.
There may be a slight
film of water over the
controls or you may be
using the tip of your
finger when touching
the controls.
Rough-edge cookware.
Unsuitable, abrasive
scourer or cleaning
products being used.
This may be caused
by the construction of
your cookware (layers
of different metals
vibrating differently).
·The hob may beep and turn
itself off, and the touch controls
may not function while there is
liquid on them. Make sure you
wipe the touch control area dry
before turning the hob back on.
What to do
Make sure the hob is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If
you've checked everything and
the problem persists, call a quali-
fied technician.
Unlock the controls. See section
'Using the hob' for instructions.
Make sure the touch control area
is dry and use the ball of your
finger when touching the controls.
Use cookware with flat and
smooth bases. See 'Choosing the
right cookware'.
See 'Maintenance and cleaning'.
This is normal for cookware and
does not indicate a fault.
EN
49