Program And Function Instruction - Klarstein Controlsync Bedienungsanleitung

PROGRAM AND FUNCTION INSTRUCTION

Power on
Connect your appliance to the mains supply, all indicator lights of the display board
will light up for 1s and then enter the clock setting state. Default time show 12:00, hour
12"flashes, the system clock setting icon
always on. The clock can be input at this time, refer to clock setting requirement for
details.
• After 10s without any operation and the oven will enter to adjust minute
automatically.
• Within 10s without any operation when adjusting minute, the oven will enter
standby mode automatically.
• In the standby state, if there is no operation within 3 minutes, it will automatically
enter the shutdown state, and the screen will not display.
• In the shutdown state, the button or function knob KB1 can be switched to the
standby state, and the standby state displays the real-time system clock and the
clock icon. (The display effect is shown in Pic 1.)
•
Time setting
In the standby mode, touching the
state. At this time, the hour value of the clock and the setting icon
and the hour is set by rotating the switch KB2. (0-23-0)
Pic 2: Hour and minute adjustment display effect
• After adjusting the hours, re-touch
flashes, and the system clock icon
Pic 1: Initial standby mode
button once to enter the system clock setting
to switch to minute adjustment. Minute
is
flashes (1s/1 time)
EN
25