Klarstein CONTROLSYNC Bedienungsanleitung Seite 73

• For your safety, this product is made of tempered glass. This type of glass is highly
resistant but has the feature to retain the memory" of shocks.
• Therefore, it should handle the product with the greatest care to avoid shocks and
twists, especially during installation.
• Avoid installing this type of product in areas where it would be highly exposed to
shocks.
• Do not let children play with the product.
• Do not stick adhesive film on the glass surface. In case of breakage, it would
generate large pieces that could be dangerous.
Electrical connection
CAUTION! Risk of electrical shock
Any electrical installation must be carried out by an authorised profes-
sional.
• All fittings must be installed by a competent person in accordance with local
regulations. If in doubt, consult a qualified electrician.
• Important! Always switch off the electricity supply at the mains during installation
and maintenance. We recommend that the fuse is withdrawn or circuit breaker
switched off at the distribution board whilst work is in progress.
• This product must be earthed – if no earth feed wire is available, consult an
electrician.
• Means for disconnection must be incorporated in the fixed wiring in accordance
with the wiring rules. To achieve this install appropriate switched fused connection
unit.
• Note! A switched fused connection unit having a contact separation of at least
3 mm in all poles should be connected in fixed wiring.
• Connect the incoming positive, neutral and earth cables to the terminals of the
switched fused connection unit. Ensure connections are tight.
• The spur outlet must still be accessible even when your oven is located in its
housing to enable the appliance to be disconnected from the mains supply.
EN
9