Programming - bürkert 8045 Bedienungsanleitung

To access the CALIBRATION MENU simultaneously press
Ensure thet the enter key is unlocked - section 3.4.1.
Reference can additionally be made to yhe menu guide - section 4.2

2.2 PROGRAMMING

See section 4.4.1
See section 4.4.2
See section 4.4.3
See section 4.4.4
See section 4.4.5
See section 4.4.6
See section 4.4.7
See section 4.4.8
See section 4.4.9
Measurement or Simulation (optional)
The actions which are highlighted in grey
measurement.
8045
QUICKSTART
Choose the
desired language
Select the desired
units
Calculate the
K factor
Select current
output range
Select the pulse
output parameters
Configure relays
1 and 2
Choose the
desired flilter
Reset the totalizer
Selection of the
AC Frequncy
5
ENTER
Ex. Select the units l/s with 1 deci-
mal point and select m
lizer display.
Ex. 4 mA = 0 l/s
and 20 mA = 10 l/s.
Ex. 1 pulse corresponds to 100 l.
(if available)
2 types of filter available each with
10 levels of damping.
To avoid resetting of the totalizer,
set the internal switch 2 into the
locked position (see 3.4.1).
To cancel any noise genera-
ted by the main AC frequency.
See next page.
must be fully completed for accurate
for 5 seconds.
3 for the tota-