bürkert 8045 Bedienungsanleitung Seite 70

Steps for successful Teach-In:
In order to determine an accurate volume, fill a tank to 100 litres of the liquid to be
measured.
When the message "TEACH Y " appears, press the ENTER key and select the
"VOLUME" option to start the measuring procedure.
The message "FILL END" (end of filling) will then appear.
After switch on a pump or open a valve
When the tank is full, switch off the pump or close the valve. If ENTER is pressed it will
end the measurement.
The user will then be asked to enter the volume (100 litres).
The calculated K-factor is displayed after validation.
The Teach-In is also available with reference to a flow meter. In this case select the "FLOW",
option on entry to the Teach-In function.
CALIBRATION
24
8045