Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROGRAM PHASES
The following table shows the processing times of the program phases in minutes.
Different time entries for one single process indicate variations due to different set-
tings of the loaf size (WEIGHT button) or browning (BURNING COLOR button).
Programm Phase
Icon
Knead 1
Rest 1
Knead 2
Rest 2
Knead 3
Ferment 1
Ferment 2
Ferment 3
Bake
Keep warm
Timer operation
KEEP WARM FUNCTION
At the end of the baking programs (1-9) the appliance automatically switches to a
keep warm function for up to 60 minutes (1 hour). In this mode, the heating compart-
ment is kept warm. Thus, the bread will not get moistened and soggy. You can can-
cel the keep warm function at any time by keeping the START/STOP button touched
for more than 3 seconds until an acoustic signal sounds.
MEMORY FUNCTION
When being live again after a power failure of up to 10 minutes, the program will
continue automatically from the same point. There is no need to touch the START/
22
Defaults
Time is adjustable
between
0:15
1 - 30 min.
0:03
0 - 30 min.
0:20
0 - 30 min.
0:10
0 - 30 min.
0:00
0 - 25 min.
0:42
0 - 60 min.
0:40
0 - 60 min.
0:00
0 - 60 min.
0:30
0 - 80 min.
medium BURNING COLOR
light, medium, dark
1:00
0 - 60 min.
up to 15 hours
STOP button. However, if the power cut-off lasts for more than 10 minutes, the actual
baking program will be cancelled completely.
Note:
After you have cancelled the baking process by pressing the START/STOP button
at least 3 seconds, all previously entered settings will be lost. In this case, you must
start the baking process again (see: "Tips for Best Results"). Thus, for short inter-
ruptions (e.g. for adding further ingredients or pushing down the ingredients back
to the kneading paddle) it is best to unplug the appliance or touch the START/
STOP button
only shortly
for pausing operation for 3 minutes at the maximum.
However, please keep in mind that the appliance will re-assume operation auto-
matically after 3 minutes.
Note:
If the program has not entered the rising phase at the moment the power supply
cuts off for more than 10 minutes, you can start the program again, without filling
in new ingredients. This way, in total, the dough will be kneaded for a somewhat
longer time duration.
PROGRAMMING YOUR OWN SETTINGS
The program Homemade (17) is reserved for your own baking program. For each
program phase, you can enter the desired time duration. To disable a program pha-
se, simply enter the time duration 0:00. This way, you can put your own special
baking ideas into practice. The program phases and default time durations are given
above (see: "Program Phases").
Note:
Your settings will be deleted from memory, after disconnecting the appliance from
power supply for more than 10 minutes. Thereafter, the defaults given in the table
above will be active again.
1. Touch the SETTING button to call the Homemade program. The program number
17 and the currently programmed total processing time will be shown on the
LCD screen.
2. Again touch the SETTING button to switch to the first program phase. The icon
and number of the program phase will be shown with the pre-set time duration
flashing.
3. Use the +TIME and -TIME buttons to set the desired time duration.
4. With the desired time duration flashing on the LCD screen, touch the SETTING
23
Werbung
Inhaltsverzeichnis
