Programming The Drive Control; A) Programming Of Full Throttle And Neutral Positions - Reely Audi R8 Bedienungsanleitung


11.

Programming the Drive Control

a) Programming of Full Throttle and Neutral Positions

For programming the full throttle positions for forward/reverse driving and the neutral position, proceed as follows:
• Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the trimming controls for driving into
the centre position.
• Switch off the speed controller. Hold down the small setup button next to the on/off switch (don't release!) and switch
the control unit switch to the „ON" position, see the figure on the right.
• When the blue LED on the control unit is lit, release the setup button.
• Move the gas/brake lever to full speed setting.
• The red and the yellow LEDs flash and then stay lit, a beep tone can be heard, the full speed setting is saved.
The beep tone is generated because the brushless motor is activated for a moment. Depending on the
motor, this beep may be very low or inaudible. In this case, observe the LED on the speed controller.
• Now move the gas/brake lever to full reverse setting.
• The red and the blue LEDs flash and then stay lit, two beep tones can be heard, the full reverse setting is saved.
• Release the gas/brake so that it sits in the neutral position.
• The red and the green LEDs flash and then stay lit, three beep tones can be heard, the neutral position setting is
saved, all LEDs cease to be lit.
• Switch the speed controller off, the programming to the remote control is complete.
If you always use the same remote control, the programming of the settings on the speed lever for your
remote control need only be carried out once and/or when you have made changes to the setup of your
remote control (e.g. adjusted the trim controller, etc.).
49