Programming The Drive Control; A) Programming Of Full Throttle And Neutral Positions - Reely Mustang Bedienungsanleitung


10.

Programming the Drive Control

a) Programming of Full Throttle and Neutral Positions

For programming the full throttle positions for forward/reverse driving and the neutral position, proceed as follows:
• Switch on the transmitter, but leave the throttle/brake in the neutral position. Put the transmitter trimming for driving
into the centre position.
• Switch off the speed controller, if you haven't done it yet already.
• Continue to press and hold the small setup button to the left of the on/off switch (do not release it!) and switch on the
speed controller now.
• When the blue LED on the speed controller is lit, release the setup button.
• Move the throttle/brake lever into full throttle for forward driving (pull the throttle all the way towards the handle).
• The red and yellow LEDs flash and then light up permanently, and the full throttle setting for forwards driving is
saved.
• Now move the throttle/brake lever into the end position for backwards driving (push throttle/brake lever at the transmitter
as far away form the handle as possible).
• The yellow and blue LEDs flash and then light up permanently, and the full throttle setting for backwards driving is
saved.
• Release the gas/brake so that it sits in the neutral position.
• The red and the green LEDs flash and then stay lit, the neutral position setting is saved, all LEDs cease to be lit.
• Switch off the speed controller; the programming to the transmitter is complete.
If you are always using the same transmitter, you only need to programme the throttle/brake lever of your
transmitter once.
Reprogramming of the full throttle and neutral positions may, however, be required if you adjust the
trimming for the drive function.
48