Putting Into Operation; Establishing The Power Supply; Establishing A Connection To The Welding Robot - Abicor Binzel iROB 501 Originalbetriebsanleitung

6 Putting into operation

6 Putting into operation

6.1 Establishing the power supply

► Note the safety instructions.
 2.4 Safety instructions for the electrical power supply on page EN-6
Electric shock due to improperly installed electrical power supply
If the electrical power supply and ground connection are improperly installed, fatal electric shocks may
occur.
► Only a trained electrician should carry out work on electrical components.
► If you want to operate the device in a very humid environment or on conductive material, install a
► Protect the power supply line to the device with suitable fuses that comply with regulations.
► Ground the device according to the applicable regulations.
► Do not ground the device together with other devices and machines.
Electric shock due to defective cables
The use of damaged or improperly installed cables may result in a potentially fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Have any damaged, deformed, or worn parts replaced by a qualified electrician only.
► Only operate the device with an undamaged power supply cable.
► Do not swap out the power supply cable.
Risk of injury due to fire
A fire may occur due to improper use or connection. This may result in serious burns.
► Ensure that the operating voltage specified on the nameplate is suitable for the mains voltage.
► Ensure that the ventilation slots are not blocked.
For the mains voltage and the fuse protection, please refer to:
 4.4 Technical data on page EN-16
► Comply with the required cable cross-sections.
► Connect the ground line as close as possible to the welding point.
► Do not swap out the power cable.
► If cables must be extended, use only original cables.
► Connect the device to the power supply at the terminals provided.

6.2 Establishing a connection to the welding robot

 13 IFR-800 fieldbus connection tool on page EN-59
EN - 18
WARNING
residual current circuit breaker in the power supply.
WARNING
WARNING
® ®
iROB 501, iROB 401, iROB
®
301