Control Elements - Abicor Binzel iROB 501 Originalbetriebsanleitung

4 Product description

4.2 Control elements

The control elements may vary depending on the product type.
Fig. 7
A Left digital display
B Right digital display
C <Parameter setting> knob
D <Toggle welding current/wire feed speed> button
E <Toggle voltage> button
F <Parameter selection> button
G <Function> button
H <Gas check> button
I <Wire feed> button
J <Welding speed> selection button
K <Welding procedure> selection button
L <Shielding gas type> selection button
M <Welding wire material> selection button
N <Welding wire diameter> selection button
O <Operating mode> selection button
X
Y
Z
AC
AB
Tab. 1
Pos. Name
A
B
EN - 10
Control elements
A AA AD
G
D
H
I
P
O N
Control elements
Left digital display
Right digital display
®
iROB
P <Tack time> button
Q <Arc dynamics> button
R <Release start welding/end crater parameter> button
S <Penetration control> button
T <Move-frequency> button
U <Cooling unit on/off> button (optional)
V <Synergy mode ON/OFF> button
W <Weld data capture> button
X <Load> button
Y <Save> button
Z <Enter> button
AA<Warning/temperature> LED
ABUSB port
ACService interface
ADIndicator LEDs
 Fig. 8 LED overview on page EN-14
B AD C
E
F
M L
Function
During welding, the welding current is displayed and
the <A> LED illuminates.
When making settings, the set value is displayed and
the corresponding LED illuminates.
The welding voltage is displayed during welding.
When making settings, the set value is displayed and
the corresponding LED illuminates.
® ®
501, iROB 401, iROB 301
Q R S W
T U V
K J