Putting Into Operation; Installing The Guide Arms; Mounting The Welding Torch - Abicor Binzel ABICAR ADVANCED 42V Originalbetriebsanleitung

ABICAR ADVANCED 42V
* Accessories
► Mount guide arms to suit your requirements with the knurled screws left and right on the device.

6.2 Mounting the welding torch

Continual contact must be ensured between the device and the workpiece. Adjustment can be made either
by means of the guide arms or the corresponding accessories.
 6.1 Installing the guide arms on page EN-14
Fig. 6
A Cross slide
B Stop lever
C Locking screw
When attaching the welding torch mount, ensure that the welding torch does not become damaged.
Attach the welding torch mount (D) with the stop levers (B).
1
Clamp the welding torch (E) into the welding torch mount (D) using the locking screw (C).
2
Roughly align the welding torch (E) with the stop levers (B).
3
Use the cross slide (A) for fine adjustment.
4
 6.4 Positioning the welding torch on page EN-16
Mounting the welding torch
A

6 Putting into operation

Setting the length
► Mount the roller unit on the other side of the
guide arm.
Adjustment of the guide arm for external edges.*
► Adjust the height of the roller using the nuts.
D Welding torch mount
E Welding torch
B
C
D
E
EN - 15