Off Function - Abicor Binzel iROB 501 Originalbetriebsanleitung

® ®
iROB 501, iROB 401, iROB
F24: Setting the wire feed speed
ON function:
The welding current is automatically set as appropriate for the wire feed speed, even if the welding
procedure is changed via the <Shielding gas type> selection button. Each time the <Parameter selection>
button is pressed, the display switches back and forth between wire feed speed and welding current.
► Press the <Parameter selection> key and activate wire feed speed.
► Enter the value in the unit [0.1 m/min].
► By switching to the welding current display, it is possible to check which welding current value was
automatically set.
The nominal wire feed speed is between 0.6 m/min. and 22 m/min. These values may differ depending on
the welding process.

OFF function:

The wire feed speed is automatically set as appropriate for the welding current, even if the welding
procedure is changed via the <Shielding gas type> selection button. Each time the <Parameter selection>
button is pressed, the display switches back and forth between wire feed speed and welding current.
► Press the <Parameter selection> key and activate the welding current.
► Enter the value in the unit [1 A].
► By switching to the welding current display, it is possible to check which wire feed speed was
automatically set.
Adjustable range
Default value
Storage option
Description
F25–F28: Setting external outputs
 6.3 Establishing a connection to higher-level control on page EN-19
F29–F32: Setting external inputs
 6.3 Establishing a connection to higher-level control on page EN-19
®
301
ON/OFF
OFF
No
OFF: Current-based.
ON: Based on the wire feed speed.
7 Operation
EN - 39