F25-F28: Setting External Outputs; F29-F32: Setting External Inputs - Abicor Binzel iROB 501 Originalbetriebsanleitung

6 Putting into operation
6.3.1 F25–F28: Setting external outputs
F25
F26
F27
F28
The following functions can be assigned to F25–F28:
Adjustable range
Default value
Storage option
Description
6.3.2 F29–F32: Setting external inputs
Sets the functions for the input terminals of the programmable I/O.
 6.3 Establishing a connection to higher-level control on page EN-19
F29
F30
F31
F32
The following functions can be assigned to F29–F32:
Adjustable range
Default value
Storage option
Description
Tab. 6
Setting
0
1
2
3
4
5
6
7
8
9
10
11
Description for setting 1
Short-circuiting the terminals opens the gas valve.
If the gas valve was opened via a signal from the external terminals, the valve is not closed automatically
after the welding process is complete or according to the run-on time (2 minutes). To close the valve again,
the terminals must be opened.
EN - 20
Set the functions for OUT-EXT1 (3–4) at the terminal block
for the external connection
Set the functions for OUT-EXT1 (5–6) at the terminal block
for the external connection
Set the functions for OUT-EXT1 (7–8) at the terminal block
for the external connection
Set the functions for OUT-EXT1 (9–10) at the terminal block
for the external connection
0/4
0
No
0: No function assigned
1–3 cannot be selected in the standard specification
Set function IN-EXT1 (5 and 9) to external terminal strip TM3
Set function IN-EXT1 (6 and 9) to external terminal strip TM3
Set function IN-EXT1 (7 and 9) to external terminal strip TM3
Set function IN-EXT1 (8 and 9) to external terminal strip TM3
0 to 11
0
No
See the following descriptions for settings 0–11
Setting external inputs
Toggle for iArc mX Standard DC/iArc mX Pulse DC
Toggle for iArc mX Move DC/iArc mX Pulse DC
® ®
iROB 501, iROB
Function
No function
Gas valve
Wire feed
Wire retraction
Start
Load welding parameters
Job shift +
Job shift −
Check cool air flow (fault)
Check cool air flow (warning)
®
401, iROB 301